Critical review for the quantification of leachate production: Evaluation example for the “Oum Azza” public landfill in Rabat city,Morocco

The estimation of leachate quantities produced in landfills is necessary to dimension the treatment plants allowing to reduce the polluting load of these effluents and consequently avoid their negative impacts on the environment. Different leachate quantification methods were used in this study to assess the leachate volume produced at the Oum Azza landfill. The water balance method give comparable estimations of leachate production to the Ouled Berjal landfill ratio. The first method showed average values between 487 and 495 m³/day for 2015, 2018, and 2019, and at the same time, the second method gave values between 470 and 477 m³/day for the same years. In contrast, the World Bank ratio showed high values that vary between 2260 and 2295 m³/day for 2015, 2018, and 2019. The on-site data and the statistical analysis showed us that the World Bank ratio is not adapted for the estimation of the leachates produced in Oum Azza landfill, while the water balance and the ratio of Ouled Berjal landfill allowed to give comparable results to reality.     

气相色谱-串联质谱法测定沉积物中多环芳烃

采用ASE法提取沉积物中16种多环芳烃,以固相萃取法净化提取液,用气相色谱-串联质谱法测定。通过优化测定条件,使方法在5.00μg/L~1 600μg/L范围内线性良好,方法检出限为0.15μg/kg~0.66μg/kg。空白石英砂的加标回收率为61.9%~121%,7次测定结果的RSD为2.6%~11.1%。     

屏蔽服冷却系统对人体表面温度影响的研究*

为科学有效地论证多种方式组合的冷却屏蔽服在不同环境条件下对人体表面温度控制的效果，需要对冷却系统及人体敏感部位发热量进行客观评估。通过对5名健康男性的高温测试，探究人体在不同环境温度下体表温度的变化，得出胸部、背部及额头为热量最高部位，并构建以“人体-降温屏蔽服-外界环境”为主体的冷却系统数值模型，对不同环境中的屏蔽服冷却效果展开研究，分析穿戴冷却屏蔽服时人体躯干部分的温度分布及影响。结果表明:在屏蔽服中靠近胸部、背部部位引入相变材料和风扇，均可帮助人体降低体温，提高舒适度。     

液氮泡沫发生器内流动特性研究

低温液氮与泡沫混合液直接接触产生氮气泡沫是一种新型的掺混形式,利用液氮高汽化比的特点,搭建液氮泡沫可视化实验装置,进行氮气-水两相流及液氮泡沫流动特性的研究。结果表明,液氮相变产生大量氮气,其与泡沫液混合产生泡沫,温度有所回升,最终趋于泡沫混合液温度;管路沿程压降较小;液氮射流破碎及流动过程可分为6个区域:低温液氮区、向上循环翻滚区、滞留区、泡沫与泡沫混合液混合区、致密泡沫区、泡沫混合液区。流体向下游流动过程中持续发泡;为防止管路结冰,需合理控制泡沫混合液与液氮流量。     

Usage of polystyrene disposable food dishes in the lightweight concrete making

The increasing use and subsequent accumulation of polystyrene containers has triggered a substantial environmental problem. This study investigated using varied percentages of solid waste polystyrene disposable food dishes in the production of lightweight concrete samples with 350 kilograms per cubic meter (kg/m³) of cement and a density of 1,300 kg/m³. The polystyrene disposable dishes were ground into beads of 0–3 millimeters (mm) and 3–6 mm in size. First, the characteristics of Type II Portland cement, polystyrene, and aggregates were examined. The following characteristics of concrete using ASTM International and British Standards Institution standards were tested: slump, compressive strength, ability to resist chloride ion penetration, and resistance of concrete to rapid freezing and thawing cycles. Scanning electron microscopy (SEM) and energy dispersive X‐ray spectroscopy analytical techniques were also used. The slump of samples varied between 40 and 70 mm and was not dependent on either the polystyrene percentage or the size of the polystyrene beads in the concrete samples (p‐value > .05). The compressive strength of the concrete samples after 90 days of curing, and using different percentages of polystyrene, varied between 96 and 113 kilograms per square centimeter (kg/cm²). The resistance of the samples to the freezing and thawing cycle and chloride ion penetration were affected unfavorably by the presence of the polystyrene. The SEM technique indicated that concrete samples containing 15% and 25% polystyrene had denser crystals and less void than concrete samples with 40% and 55% polystyrene.     

山东省主要河流中抗生素污染组成及空间分布特征

采用固相萃取-液相色谱/串联质谱法研究了山东省境内四大流域主要河流中抗生素污染组成及空间分布特征,涉及我国用量最大的6类共20种抗生素。结果表明:20种抗生素均有检出,且大环内酯类、喹诺酮类和四环素类抗生素整体检出浓度较高。就流域而言,半岛诸河流域抗生素污染较小,平均总质量浓度61.4 ng/L;海河流域、小清河流域和淮河流域相对较为严重,平均总质量浓度分别为232、175、118 ng/L。抗生素空间分布呈现一定的规律,检出浓度较高的点位主要集中在人口密集区下游,抗生素污染与周边生活污水、养殖企业废水和城市污水处理厂排水密切相关,而且抗生素组成可从一定程度上反映出污染来源。     

CePO4-TiO2固溶体的NH3-SCR活性

采用共沉淀法合成了不同Ce与Ti摩尔比的CePO₄-TiO₂复合材料,利用XRD、TEM、NH₃-TPD和H₂-TPR技术对其物理化学性质进行了表征,并对其NH₃-SCR活性进行了评价。实验结果表明：随着CePO₄含量的增加,催化剂的活性提高;当Ce与Ti的摩尔比为8:2时催化剂的活性最高,230 ℃的NO转化率达到100%,且具有更广的温度窗口,优于纯CePO₄。表征结果显示,CePO₄与TiO₂形成固溶体后,颗粒尺寸较为均匀,强酸位的数量增多,氧化还原性能提升,从而提高了催化剂的SCR反应活性,同时改善了其抗水抗硫性能。     

基于ZIF-L的微固相萃取技术测定地表水中痕量典型多环芳烃

制备类沸石咪唑酯骨架ZIF-L材料,将其用作微固相萃取吸附剂,处理水中萘、苊、苊烯、芴、菲、蒽、荧蒽、芘等8种痕量典型多环芳烃,再用HPLC测定。试验表明,ZIF-L对上述多环芳烃的萃取效率明显高于商品化萃取材料C 18和多壁碳纳米管。方法在0.100μg/L^200μg/L范围内线性良好,方法检出限为0.02μg/L^0.03μg/L,标准溶液5次测定结果的RSD为4.7%~9.5%,实际水样加标回收率为84.5%~115%。将该方法用于北太湖5个点位水样的测定,测定值为未检出~3.40μg/L。     

平煤十矿底板巷穿层钻孔瓦斯抽采模拟研究

为了降低平煤十矿己15-16-24130工作面运输巷掘进中的突出危险性，基于实际工程背景，考虑瓦斯抽采中的瓦斯运移及煤岩变形等因素，建立了瓦斯抽采气固耦合模型，并利用COMSOL Multiphysics软件对平煤十矿己15-16煤层的底板巷穿层钻孔瓦斯抽采方案进行数值模拟，研究了瓦斯抽采对于降低掘进过程中突出危险性的影响。研究结果表明:在己18煤层开挖底板巷对己15-16煤层进行穿层钻孔瓦斯抽采，瓦斯抽采180 d后，己15-16-24130工作面运输巷附近煤层残余瓦斯压力及瓦斯含量分别降至0.315 MPa和3.84 m3/t；将底板巷穿层钻孔瓦斯抽采方案进行工程应用，实测抽采后的残余瓦斯压力及瓦斯含量在0.32 MPa和3.17 m3/t，均小于平煤十矿煤与瓦斯突出防治规定的“双6”指标（残余瓦斯压力小于0.6 MPa，残余瓦斯含量小于6 m3/t），可有效降低运输巷掘进过程中的突出危险性。     

金属粉尘湿法处理系统的设计和除尘效果分析

为改善金属抛光操作人员的工作环境、降低抛光金属粉尘的爆炸风险，设计一种金属粉尘湿法处理系统，并通过建立多相流动数值模型，探究其内部流场特征与金属粉尘运动规律，分析金属粉尘湿法处理系统的除尘效率。研究结果表明:大粒径的金属粉尘直接重力沉降至水槽中；小粒径(PM10)的金属粉尘易随气流进入风道，进而通过水雾脱除；采用洁净进气源，可以有效降低工人操作环境的粉尘浓度；增加细水雾，可以有效提高金属粉尘湿法处理系统的除尘效率，对PM10的除尘效率从30%提升至82%。